Concrete Sidewalk Building in Concord NC - A firm, straight walk to your door
Sized, graded and jointed before the pour
We build concrete sidewalks in Concord to a planned width and thickness, from a front walk to a path along the street. Most calls start with a cracked, sinking walk or a yard with no path. I come out, we agree on the width and where the grooves go, then we price it.
A concrete sidewalk built from the base up
A sidewalk is flatwork, the trade's word for a flat slab on the ground, and most of the job is under it. We dig out, pack the base and set the forms, then pour, finish and cut the grooves.
Length, width, tearing out an old walk and a plain or decorative concrete finish move the price, and the weather moves the schedule. My written estimate puts a figure on your walk and spells out what's included and what isn't.
Best for
- Front walks to the door
- Paths to the driveway
- Walks along the street
- Replacing a cracked walk
Width settled up front
We settle the width and where the grooves go with you before we price it, so you know exactly what our number covers next to other bids.
Cracks in planned places
Concrete will crack somewhere, so we cut control joints, straight grooves across the walk, that give a crack a place to run instead of wandering across the middle.
Water runs off, not in
Before we set forms, we check where the water runs and pitch the walk slightly away from your house, so rain doesn't pool against the foundation.
Clean, rounded edges
We run an edging tool along both sides while the concrete is still wet, which rounds the corners so they're less likely to chip when a mower clips them.
A lasting concrete sidewalk starts with who pours it
- I come out to measure and write the estimate, then I'm on site while our own crew forms, pours and finishes your walk.
- I learned on my father's crews around Concord and started this business in 2017, and we're known for driveways, patios and steps that come out straight and clean.
- We're licensed and fully insured, and every walk we pour is backed by our satisfaction guarantee.
Choices for your new sidewalk
I'll walk you through these on site and tell you which are worth the money. If the budget's tight, put it into the base under the walk, because a nicer finish won't save a walk that sinks.
Broom finish
A stiff broom dragged over the fresh surface leaves fine ridges that give shoes grip in the rain, and it suits most walks.
Decorative border
A stamped or colored band along each edge dresses up a front walk without paying for a pattern across the whole thing.
Rebar for heavy spots
Rebar, steel bars set inside the slab, holds cracked pieces tight and level, which matters most where a vehicle might cross the walk.
Poured with other work
If we're also pouring a garage floor, we can form the walk to the side door so it meets the slab cleanly.
Tell us about your walk
Send your address and the walk's rough length and width, or call. We reply within one business day, then I come out for a free on-site estimate, with no obligation.
Sidewalk questions from Concord homeowners
How much does a concrete sidewalk cost near Concord?
A standard flat concrete sidewalk in the Charlotte area usually costs about $4 to $12 per square foot, including materials and labor. That's the going rate around here, not our price, and where your walk falls depends on its size, any tear-out and the finish. I'll put your figure in writing after I see it.
Who handles building permits and inspections in Cabarrus County?
The Cabarrus County Construction Standards Division issues building permits and handles inspections across the whole county, Concord included. It also enforces the state building code and local rules. When a walk needs a permit, we handle the application and the scheduling with that office, and I'll tell you up front if yours does.
How wide is a standard concrete sidewalk in North Carolina?
North Carolina's roadway standard calls for a sidewalk 5 feet wide and 4 inches thick, unless the plans for a job give another size. A walk to your door can be sized differently, so check the width and thickness each quote is pricing before you compare them.
How do I check a concrete contractor's license in North Carolina?
Ask the contractor for the license name and number, then search them on the state licensing board's site to see whether the license is active. The board's definition of a general contractor covers anyone who bids on or builds an improvement costing $40,000 or more. Do the search before you sign.
How do I find out who maintains my street in Concord?
Concord's Streets Maintenance map, linked from the city's transportation page, shows who maintains a given road, so look yours up before planning a walk along the street. We check that first on these jobs too. For a missing piece of public sidewalk, the city takes requests through its Active Transportation Program and ranks them by points.
Other concrete work we do
Garage floor concrete
A worn or cracked garage slab can be poured new while our crew is already set up at your house.
Explore Garage floor concreteDecorative concrete
Stamped borders, color or exposed stone can turn a plain front walk into the entry people notice first.
Explore Decorative concrete